1999 Chevrolet Chevy Suburban Transfer Case Internal Components Assemble
download 1. 2. 3. 4. 5. Install the spring retainers to the synchronizer hub. Align the scribe marks previously made on the synchronizer hub and the synchronizer sleeve. Install the synchronizer hub to...
View Article2002 Chrysler Voyager Front Evaporator Core Replacement
download REMOVAL WARNING: REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE FOLLOWING OPERATION. 1. Remove the HVAC unit housing from the vehicle. See: Housing...
View Article2000 Ford Expedition Evaporator Core REMOVAL AND INSTALLATION
download Removal and Installation NOTE: If an A/C evaporator core leak is suspected, the A/C evaporator core must be leak tested before it is removed from the vehicle. For additional information, refer...
View Article1991 Chevy G 20 Van Heater Core: Service and Repair Primary (Front) Heater Core
download Remove or Disconnect (Figures 5 through 10 and Figure 20) 1. Battery ground cable. 2. Coolant recovery tank. 3. Heater core hoses (140 and 141) (figures 6, 7, 8 and 20). ^ Place a clean pan...
View Article2000 Jeep Grand Cherokee Heater Core: Service and Repair
download REMOVAL 1. Remove the heater-A/C housing from the vehicle. See: Housing Assembly HVAC/Service and Repair 2. Remove the foam gasket surrounding the core tubes. NOTE: Notice the orientation of...
View Article2001 Ford Taurus V6-3.0L DOHC With Damaged Evaporator Core Orifice Service...
download SPECIAL TOOL(S) 1. Remove the condenser to evaporator line. 3. Index mark the condenser to evaporator line. Disconnect the two halves of the condenser to evaporator line. 4. Inspect the...
View Article2003 Pontiac Grand Prix Heater Core Replacement
download Tools Required J 38185 Hose Clamp Pliers Removal Procedure 1. Remove the fuel injector sight shield (3.8L only). Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical-3.8L. 2....
View Article1986 Chevy Truck C 10 P/U Steering Column: Service and Repair Assembly
download 1. To assemble bearing housing, proceed as follows: a. Using a suitable socket, press bearings into bearing housing. b. Install lock shoe springs, lock shoes and shoe pin into bearing housing....
View ArticleBuick Enclave: A New Generation SUV
On May 2007, the division of General Motors launched its new SUV model for 2008, the Buick Enclave. Buick Enclave is a full-size luxury crossover SUV. It is partially based on the Buick Centieme shown...
View Article2001 Mazda B3000 SE Regular Cab How to EVAPORATOR CORE REMOVAL / INSTALLATION
download To prevent system contamination, whenever the evaporator core is replaced, also replace the receiver/drier. NOTE: The evaporator core is not separately serviceable, it is serviced only with...
View Article